Scantronic 9651 reset codes

We have come across a Scantronic 9651 but we do not know any of the codes both user and engineer are you able to tell us how to reset these codes?

The Scantronic 9651 engineer programming guide and installation manual is in our manuals section please click here to view Scantronic 9651

If you take a look on page 31 there is the full instructions for returning the panel to factory restore codes without affecting all other programming, I have copied the page here.

Restoring Default Access Codes Scantronic 9651 (first stage reset)

The default (original) access codes are:

4-digit 6-digit

Engineer Code 7890 567890

Access Code User 1 1234 123456

To restore all access codes to their default settings:

1. Remove mains power.

2. Open the case and disconnect the battery.

3. Identify the NVM Reset pins and Kick Start pins on the main PCB (refer

to Chapter 3).

4. Short circuit the NVM Reset pins with a wire link.

5. Short circuit the Kick Start pins with a wire link.

6. Reconnect the battery.

7. Remove the wire links from the NVM Reset pins and Kick Start pins.

The control unit will load the factory default access codes listed above.

8. Close the control unit.

9. Apply mains power.

10. Carry out an engineer reset (see next section).